In summer, in order to prevent unnecessary accidents, the power supply of concrete mixer should be taken seriously. Therefore, it is imperative to strengthen the power management of automatic feeding mixer. So, how to strengthen the power management?

首先，该行业有专注化，寻找专注电工安装。安装自动上料搅拌车时，应竖立电线，安装和维护的电气设备应由有资格进行检查的电工按照电源设计规范，程序和合理安装进行。使用电加热器和各种电气设备时，须由专人负责使用和管理，离开时须切断电源。

First of all, the industry has focus, looking to focus on electrical installation. When the automatic feeding mixer truck is installed, the electric wires shall be erected, and the electrical equipment shall be installed and maintained by qualified electricians according to the power supply design specifications, procedures and reasonable installation. When using the electric heater and various electrical equipment, it must be used and managed by a specially assigned person, and the power must be cut off when leaving.

加强安 全知识的培训和管理。临时电力线的安装应根据固定电源的规格设定。电源线应位于隐蔽装置内，电源线应竖立在安 全的地方，以避免接触，挤压或悬挂。禁止使用电炉和各种电热器具进行保温和烹饪。

Strengthen the training and management of safety knowledge. The installation of temporary power line should be set according to the specification of fixed power supply. The power cord shall be located in the concealed device, and the power cord shall be erected in a safe place to avoid contact, extrusion or suspension. It is forbidden to use electric furnace and various electric heating appliances for heat preservation and cooking.

做好定期检查。务必检查自动上料搅拌车的电线和电气设备，发现可能造成的任何短路，火灾，高温或绝缘不好，须立即进行维修或更换。禁止使用不合格的安 全装置，不允许使用铜线，铁线或铝线代替保险丝。电气设备的电源线不得超过安 全负载。

Do a good job of regular inspection. Be sure to check the wires and electrical equipment of the automatic feeding mixer. If any short circuit, fire, high temperature or poor insulation is found, repair or replace them immediately. It is forbidden to use unqualified safety devices, and it is not allowed to use copper wire, iron wire or aluminum wire instead of fuse. The power line of electrical equipment shall not exceed the safe load.