蓄电池是
自动上料搅拌车上一个关键的设备，可以供应汽车打火、供电系统的要求，一般的蓄电池是可以应用很长期的，但假如长期忘掉拆换或是是维护保养不足好的话，就很有可能会碰到忽然无电的状况，这个时候搅拌车很有可能连起动都变成难题，就对于这一难题厂家为大伙儿出示二点解决方式:
The storage battery is a key equipment on the automatic feeding mixer, which can meet the requirements of the ignition and power supply system of the vehicle. Generally, the storage battery can be used for a long time. However, if the replacement is forgotten for a long time or the maintenance is not good enough, it is very likely to encounter a sudden lack of power. At this time, the mixer is likely to become a problem even for starting. The manufacturer presents two solutions to this problem:
一、钢筋搭接起动。假如碰到状况时也有同行业的车，车里也有接地电缆时，还能够选用蓄电池钢筋搭接的方式起动车子。具体步骤时先将两辆车挨近，直至接地电缆充足联接二块蓄电池的正负。要留意保证两辆车没有触碰，只容许应用具备充足的承载力且带绝缘层表皮的电缆。假如出示开关电源的蓄电池在车子上的安装部位不方便立即开展接地，则务必应用专用工具将蓄电池拆下来。
1、 Rebar lapping start. If there is a car in the same industry in case of a situation, and there is a grounding cable in the car, you can also start the car in the way of overlapping the battery reinforcement. In the specific steps, first approach the two vehicles until the grounding cable is sufficiently connected to the positive and negative of the two batteries. Pay attention to ensure that the two vehicles do not touch. Only cables with sufficient bearing capacity and insulation skin are allowed to be used. If the installation position of the battery with switching power supply on the vehicle is not convenient for immediate grounding, it is necessary to remove the battery with special tools.
明确二块蓄电池的正级和负级，应用电缆将正级与正级、负级与负级各自连起来。要留意蓄电池的正负一定不要弄错，并且要确保电缆的靠谱联接。布局好电缆的走向，避免 起动时电缆与胶布或散热风扇刮蹭。
Define the positive and negative stages of the two batteries, and connect the positive and negative stages and the negative and negative stages respectively with cables. Pay attention to the positive and negative of the battery, and make sure that the cable is connected reliably. Lay out the direction of the cable to avoid scratching the cable with the adhesive tape or the cooling fan when starting.
关掉车里全部附设用电量机器设备，起动出示开关电源的蓄电池所属的车子，使其柴油发动机运行数分钟以确保用电量充裕。随后按一切正常方法起动没电车子，起动后应轻踩加速踏板，使柴油发动机以2000r/min的转速比运行数分钟。随后关掉两辆车的启动马达，当心拆卸电缆，留意防止正负电缆连接头碰撞。
Turn off all the auxiliary power consumption machines and equipment in the vehicle, start the vehicle with the battery showing the switching power supply, and run the diesel engine for several minutes to ensure sufficient power consumption. Then, start the car without electricity according to all normal methods. After starting, gently step on the accelerator pedal to make the diesel engine run at the speed ratio of 2000r / min for several minutes. Then, turn off the starting motors of the two vehicles, carefully remove the cables and prevent the positive and negative cable connectors from colliding.
二、牵引起动。牵引起动的方式与基本原理与手推车起动如出一辙，不一样的是出行牵引通常省劲方便得多。落实措施时应用长短适度的牵引绳，并将两边绑扎牢固。
2、 Traction start. The mode and basic principle of traction starting are the same as that of trolley starting. The difference is that the traction is usually much more energy-saving and convenient. During the implementation of measures, the traction rope with appropriate length shall be used, and both sides shall be bound firmly.
在牵引前，前后左右车司机先要明确好联系数据信号，比如发展和泊车是警笛提示还是做手势提示，便于融洽相互配合。要慢速度发展，前车司机除应留意后车趋势外，还应随时随地留意地面上的交通条件。后车司机在车子起动后应立即提示前车，两辆车应迟缓挨近违章停车。
Before traction, drivers of front, rear, left and right vehicles should first make clear the contact data signals, such as whether the development and parking are siren prompts or gesture prompts, so as to facilitate harmonious cooperation. To develop at a slow speed, drivers in front should not only pay attention to the trend of vehicles behind, but also pay attention to the traffic conditions on the ground at any time. The driver of the rear vehicle shall prompt the front vehicle immediately after the vehicle starts, and the two vehicles shall slowly approach the illegal parking.
What should I do if the battery of the mixer truck is dead? I hope the above two points can bring you good help. Come to our website for more relevant content http://www.jfhntjbj.com Consult.
点击拨打服务热线：400-879-1999
