What should be paid attention to when adding fuel for automatic feeding mixer?

1.自动上料搅拌车在运行过程中不得维修和润滑。

1. The automatic feeding mixer shall not be maintained and lubricated during operation.

2.定期向注油嘴注满润滑脂，每4小时向轴端密封圈注满润滑油，并每周排放一次污水。

2. Fill the grease nozzle with grease regularly, fill the shaft end sealing ring with lubricating oil every 4 hours, and discharge the sewage once a week.

3.使用自动上料搅拌车后，在每个润滑点适当添加必要的润滑油。

3. After using the automatic feeding mixer, add necessary lubricating oil at each lubricating point.

4.自动上料搅拌车齿轮箱的齿轮和轴承通过齿轮旋转将油溅到箱内壁上，并流入轴承进行润滑。变速箱的油位应保持在油尺的两个刻度之间。如果油位过高或过低，每个零件的温度将升高或润滑不良，这将增加功率损耗并导致机器工作不良。

4. The gear and bearing of the gearbox of the automatic feeding mixer splash oil on the inner wall of the box through the rotation of the gear, and flows into the bearing for lubrication. The oil level of the gearbox should be maintained between the two scales of the dipstick. If the oil level is too high or too low, the temperature of each part will increase or the lubrication will be poor, which will increase the power loss and cause the machine to work poorly.

5.自动上料搅拌车选择的润滑油应具有一定的购置粘度和粘度温度特性，凝固点低，抗氧化稳定性好，无机械杂质和湿气，无腐蚀和磨损物。其质量指标应符合标准。

5. The lubricating oil selected for the automatic feeding mixer should have certain viscosity and viscosity temperature characteristics, low freezing point, good oxidation stability, no mechanical impurities, moisture, corrosion and wear. The quality index should meet the national standard.

自动上料搅拌车加油的注意问题就是这些，希望对你有帮助。

These are the problems that should be paid attention to when filling the automatic feeding mixer. I hope it will help you.