油泥是长期用矿物油留下的，特别是加了机油添加剂的搅拌一体车发动机，更容易积油泥。那么搅拌车油泥影响体现在哪方面？要这么呢？下面由厂家为大家分析搅拌一体车如何清理油泥。

Oil sludge is left by mineral oil for a long time, especially for the engine of the agitator car with engine oil additives, which is easier to deposit oil sludge. What are the impacts of sludge from mixer trucks? How about this? Next, the manufacturer will analyze how to clean the sludge of the mixer truck.

搅拌车油泥影响体现：

The influence of sludge on the mixer truck is reflected in:

1.冷启动困难，冷车怠速达不到规定的转速，严重时冷车怠速会熄火，热车后怠速低。

1. It is difficult to start cold. The idle speed of the cold car cannot reach the specified speed. In severe cases, the cold car will stall at idle speed, and the idle speed will be low after the hot car.

2.发动机动力下降，加速不畅，油耗增加。

2. Engine power drops, acceleration is not smooth, and fuel consumption increases.

3.发动机尾气排放变差，同时也会缩短火花塞、氧传感器、三元催化器的使用寿命。

3. Engine exhaust emissions become worse, which will also shorten the service life of spark plugs, oxygen sensors and three-way catalytic converters.

4.积碳也会造成发动机的活塞环的卡滞，影响活塞环的密封性能，搅拌车造成机油消耗量增加，导致发动机烧机油，缩短了发动机的使用寿命。

4. Carbon deposition will also cause the piston ring of the engine to be stuck, which will affect the sealing performance of the piston ring. The mixer truck will cause increased oil consumption, which will lead to engine oil burning and shorten the service life of the engine.

要这么：

To solve this problem:

如果油泥实在太厚，而你又不想拆发动机的话，可以把气门室盖和机油底壳拆下来，用柴油浸泡，再用汽油刷洗既可，特别是机油泵，一定要拆下来仔细清洗，但拆一次盖子和油底壳就要更换垫子。

If the sludge is too thick, and you don't want to remove the engine, you can remove the valve cover and oil pan, soak them in diesel oil, and then brush them with gasoline. Especially the oil pump, you must remove it and clean it carefully, but replace the gasket when you remove the cover and oil pan.

一般不拆发动机有两种简单清洗方法，一种添是加在机油里的清洗油，还有一种是用机器接在发动机上，用一种清洗剂循环冲洗。搅拌车发动机里的油泥想清洗，须要把发动机解体，用超声波机才清洗的干净。

Generally, there are two simple cleaning methods without disassembling the engine. One is to add cleaning oil to the engine oil, and the other is to connect the machine to the engine and use a cleaning agent for circulating flushing. If you want to clean the sludge in the engine of the mixer, you need to disassemble the engine and use an ultrasonic machine to clean it.

先用一块破布大致上清理一下，然后稍微放一点汽油出来用毛刷惉上把剩下的不好清理的往下刷。刷完以后用换下的机油或者机油瓶里剩余的那点底子惉毛刷上边再给上一层油就行了。一般也不会专门去清理。

First, roughly clean it with a piece of rag, then put a little gasoline out and use a brush to brush down the rest that is not easy to clean. After brushing, use the replaced engine oil or the remaining base in the engine oil bottle to make up the brush and apply another layer of oil. I don't usually go to clean it up.

拆下来先用洗洁精加水洗头遍，再用柴油洗再上机油，然后用布把多余的机油抹干净，上到车子上就可以了。平时用淘汰的儿童牙刷沾点机油刷前后齿的接触部位，尽量少而均匀，这样才少沾灰尘。

After removal, first wash your head with detergent and water, then wash it with diesel oil, and then add engine oil. Then wipe the excess engine oil with a cloth, and then put it on the car. At ordinary times, use the eliminated children's toothbrush to brush the contact parts of the front and rear teeth with oil as little as possible, so as to reduce the dust.

拆下链条，把链条放入大的可乐瓶中，倒入适量清洗剂，盖上盖子，摇晃数次，取出装上。

Remove the chain, put the chain into a large Coke bottle, pour in a proper amount of cleaning agent, cover it, shake it several times, take it out and install it.

搅拌车油泥影响体现在哪方面？以上就是问题的相关解答以及应对方法了，您可以当参考内容看看，更多的注意事项就来我们网站http://www.jfhntjbj.com咨询吧！

What are the impacts of sludge from mixer trucks? The above is the answer to the question and the solution. You can refer to it as a reference, and come to our website for more precautions http://www.jfhntjbj.com Consult!