Mixer truck and other concrete machinery will inevitably have some faults in the long-term use process. At this time, we need to clean the mechanical soil slag. So let's take a closer look at how to clean up the soil properly.

1、准备应急驱动软管，关闭搅拌车，然后拆下液压马达上的高压油管接头。

1. Prepare the emergency drive hose, turn off the mixer, and then remove the high pressure oil pipe connector on the hydraulic motor.

2、救援车关闭，液压马达的高压油管被拆除，故障车辆上的相应连接器与应急驱动软管连接。

2. The rescue vehicle was closed, the high-pressure oil pipe of the hydraulic motor was removed, and the corresponding connector on the faulty vehicle was connected with the emergency drive hose.

搅拌一体车

Mixer truck

3、启动救援车并将其手柄转到卸货位置。故障车辆内的混凝土排出。

3. Start the rescue vehicle and turn its handle to the unloading position. The concrete in the faulty vehicle is discharged.

4、紧急驱动完成后，拆下驱动软管并恢复两辆车的原始状态。

4. After the emergency drive is completed, remove the drive hose and restore the original state of the two vehicles.

5、在滚轮和滚道之间放置一个木质楔子，以控制搅拌车的旋转。一定要注意。关闭发动机并拆下液压马达的高压油管。搅拌车可以自由旋转。

5. A wooden wedge is placed between the roller and the raceway to control the rotation of the mixer. We must pay attention to safety. Shut off the engine and remove the high pressure oil line from the hydraulic motor. The mixer can rotate freely.

6、控制搅拌筒的旋转，将维护孔转到下部，然后打开维护孔清理缸内的混凝土。这时，一定要注意。混凝土卸料后，恢复原来的全自动一体式搅拌车。

6. Control the rotation of the mixing drum, turn the maintenance hole to the lower part, and then open the maintenance hole to clean the concrete in the cylinder. At this time, we must pay attention to safety. After concrete unloading, the original full-automatic integrated mixer is restored.