The longer the working time of the automatic mixer is, the problems will be encountered, such as deviation of the belt conveyor, non feeding of the intermediate transition silo, jamming of the aggregate feeding door, slipping of the belt conveyor in rainy days, slow feeding of powder and so on. In case of such problems, the production of the whole concrete production line may be affected. Therefore, finding the problem in time and finding a solution can increase the output and reduce the loss. In this paper, the automatic mixer manufacturer will introduce to you how to solve the problem of no feeding in the intermediate transition bin of the automatic mixer.

1.在自动搅拌车生产过程中如出现中间过度仓不往搅拌机内卸料，就应该检查粉灰秤、水泥秤、外加剂秤、水秤是否已经称量到位，中间过度仓的限位开关是否检测到位，搅拌站搅拌主机卸料门是否关门到位。

1. In the production process of automatic mixer truck, if the intermediate transition bin does not unload into the mixer, check whether the powder ash scale, cement scale, admixture scale and water scale have been weighed in place, whether the limit switch of the intermediate transition bin is detected in place, and whether the unloading door of the mixing host of the mixing plant is closed in place.

2.检查自动搅拌车搅拌主机内有没有料，如果还没卸料，搅拌时间到可以按下卸料门按钮，先进行卸料。

2. Check whether there is material in the mixing host of the automatic mixer. If it has not been unloaded, press the unloading door button when the mixing time is up, and unload the material first.

3.混凝土搅拌站皮带延时未到设定值亦不投料；料门被卡住打不开，开门气缸感应器没有检测到位或失灵，气缸串气，密封件损坏，开门机构不够灵活，气压不够，气缸失灵等原因也应该还加以考虑。

3. The belt of the concrete mixing plant will not be fed until the time delay reaches the set value; The material door is stuck and can not be opened, the door opening cylinder sensor is not detected in place or fails, the cylinder is crosstalk, the seal is damaged, the door opening mechanism is not flexible enough, the air pressure is not enough, the cylinder fails and other reasons should also be considered.

4.搅拌站中间过度仓打开后再关上的时候无法检测到关门信号，应该先用搅拌站手动开关门开关试，如果还不行就应该检查限位开关以及线路时好时坏、是否异味松脱、门板上是否有集料粘在上面，或开门机构的调节螺栓是否松动，没有调节到位。

4. If the door closing signal cannot be detected when the intermediate transition bin of the mixing plant is opened and then closed, the manual door opening and closing switch of the mixing plant should be used first. If not, check the limit switch and whether the line is good or bad, whether the peculiar smell is loose, whether there is aggregate stuck on the door plate, or whether the adjusting bolt of the door opening mechanism is loose and not adjusted in place.

5.卸料门接近开关没有检测到位或接近开关损坏，重新调整位置或更换。

5. If the proximity switch of the discharge door is not detected in place or the proximity switch is damaged, readjust the position or replace it.