应定期向与自动上料搅拌车相连的水箱中加水。

Water shall be added to the water tank connected to the automatic loading mixer on a regular basis.

，控制油箱压力并经常拧紧各种配件

First of all, control the tank pressure and tighten various fittings frequently

无需调整储罐中的压力设置。如果在特殊情况下需要调节，建议将压力控制在3.5Mpa左右。另外，在使用新车或日常使用时，请确保将其拧紧，以免连接器脱落。

There is no need to adjust the pressure setting in the tank. If adjustment is needed under special circumstances, it is recommended to control the pressure at about 3.5Mpa. In addition, when using a new car or daily use, please make sure to tighten it to prevent the connector from falling off.

二，油轮加水步骤

2、 Tanker filling procedure

每个油轮都有类似的供水。通常情况下，水箱要用水通风-阀门是关闭的。在不使用时将其居中。

Each tanker has a similar water supply. Normally, the tank is ventilated with water - the valve is closed. Center it when not in use.

三，冬季水箱中剩余的水

3、 Remaining water in the tank in winter

在冬季，特别是在北方，用户需要从水箱和管道中排出水，将压缩空气吹入管道中，并从每根管道中排出残留水。防止因冻结而冻结和破裂管道。

In winter, especially in the north, users need to drain water from water tanks and pipes, blow compressed air into pipes, and discharge residual water from each pipe. Prevent freezing and rupture of pipes due to freezing.

卸料过程中自动上料搅拌车的注意事项

Matters needing attention of automatic loading mixer in discharging process

1.以大速度操作混合箱1-2分钟，然后降低其以彻底搅拌混凝土。

1. Operate the mixing tank at high speed for 1-2 minutes and then lower it to thoroughly mix the concrete.

2.排干物料后，将汽车尽可能停在平坦的表面上，并弄湿料斗斜槽以利于清洁。

2. After discharging the materials, park the car on a flat surface as far as possible, and wet the hopper chute to facilitate cleaning.

3.取出时查看材料，以免操作弹出杆。在转动中间位置时停止油箱，以保护减速器，支撑轮等。

3. Check the material when taking it out to avoid operating the pop-up lever. Stop the oil tank when turning the middle position to protect the reducer, support wheel, etc.

4.清洗瓶子时，必须仔细清洗，将水反复倒转两次，将水箱中的水放进瓶子后放回站内，并向瓶子中加水。彻底清洁。

4. When cleaning the bottle, you must wash it carefully. Turn the water back twice. Put the water in the water tank into the bottle and put it back into the station, and add water to the bottle. Clean thoroughly.

为了在自动上料搅拌车设备运行期间确保设备的良好运行性能，有必要了解这些注意事项。避免由于对设备的了解不足而影响正常施工过程的操作错误。

In order to ensure the good operation performance of the equipment during the operation of the automatic feeding mixer, it is necessary to understand these precautions. Avoid the operation error that affects the normal construction process due to insufficient understanding of the equipment.

自动上料搅拌车储水罐加水步骤和卸料的注意问题就是这样了，希望对你有帮助。

Automatic feeding mixer tank water tank filling steps and unloading attention is like this, hope to help you.

自动上料搅拌车

Price of automatic feeding mixer