Paying attention to details is the principle we should abide by, especially when driving an automatic feeding mixer. The details to be done when driving a self feeding mixer:

1、随车带上减水剂：减水剂是一种在维持混凝土坍落度不变的条件下，能减少拌合用水量的混凝土外加剂，随车携带，能对混凝土进行很好的调节。

1. Carry water reducing agent with the vehicle: water reducing agent is a concrete admixture that can reduce the mixing water volume under the condition of maintaining the same concrete slump. It is carried with the vehicle and can well adjust the concrete.

2、回厂检查罐内水量：每次出车任务完成回到站内的时候，检查储水罐内的水量，让水罐中的水随时处于满罐的状态，以备不时之需。

2. Return to the factory to check the water volume in the tank: when returning to the station after completing the driving task, check the water volume in the water storage tank to keep the water in the tank full at any time for emergency needs.

3、离厂前检查混凝土质量：可能会因为原料的不同，每一盘混凝土质量都会有变化。

3. Check the concrete quality before leaving the factory: the quality of each plate of concrete may change due to different raw materials.

4、减少车辆行驶时间：混凝土运距一般在直径30千米范围以内，出车之前规划好路线以及车辆通行情况。

4. Reduce vehicle travel time: the concrete transportation distance is generally within 30 km in diameter, and the route and vehicle traffic shall be planned before departure.

5、减少损失先卸料：如果遇到人为因素或者不可抗因素，导致长时间无法卸料的情况，一旦发现混凝土开始凝结，在报备负搅拌责自动上料搅拌车防止粘罐的方法人之后立刻进行卸料，以防整个罐体报废。

5. Unloading first to reduce losses: in case of failure to unload for a long time due to human factors or irresistible factors, once it is found that the concrete begins to set, the unloading shall be carried out immediately after reporting the method of automatic loading mixer in charge of mixing to prevent sticking to the tank, so as to prevent the whole tank from being scrapped.

卸料前让搅拌罐全速运转一两分钟。让混凝土充分搅拌，必要时可以加一些水，让混凝土搅拌得更均匀，也方便卸料。卸料不要大意和放料工打好关系。放料时尽量自己看着，免得放料工乱操作放料操作杆，每次罐子正反转中间位子时尽量停一下，保护减速机，托轮等。

Let the mixing tank run at full speed for one or two minutes before unloading. Allow the concrete to be fully mixed. If necessary, add some water to make the concrete mix more evenly and facilitate unloading. Don't be careless in discharging and have a good relationship with the discharging worker. Try to watch by yourself when discharging, so as to prevent the discharging worker from operating the discharging operating rod disorderly. Try to stop every time the tank is in the middle position in reverse, so as to protect the reducer, supporting wheel, etc.

与放料工打好关系，卸料时也不要睡的太熟，万一工人闹情绪，把你车子放到工地不转罐子，造成闷罐就麻烦了。

Make a good relationship with the discharging workers. Don't sleep too well during unloading. In case the workers are in a mood, put your car on the construction site and don't turn the cans, which will cause trouble for stuffy cans.

6、搅拌罐一定要仔细地冲洗干净。洗罐子时一定要仔细的冲洗干净，并把水反复的正反转两次，再放出来，然后一趟时把水箱的水全部放进罐子，再回到站加水清洗罐子。

6. The mixing tank must be washed carefully. When washing the tank, be sure to wash it carefully, and repeat the positive and negative rotation of the water twice, and then put it out. Then put all the water in the water tank into the tank, and then go back to the station to add water to clean the tank.

以上是驾驶自动上料搅拌车一定要做的事情，而且细节问题要做好。

The above is what must be done to drive the automatic feeding mixer, and the details should be done well.