自动上料搅拌车作业中会出现各式各样的问题，全看操作人员要如何去，不及时就会出现大的损失。那么自动上料搅拌车作业中出现土渣问题怎么处理？

　　There will be all kinds of problems in the operation of automatic feeding mixer. It all depends on how the operator wants to solve them. If they are not solved in time, there will be big losses. So how to deal with the problem of soil slag in the operation of automatic feeding mixer?

　　应准备好紧急驱动软管，将机械熄火，卸下液压马达上的高压油管接头。将救援车熄火，将液压马达的高压油管拆卸，并与故障车上的相应接头利用紧急驱动软管相连接。

　　First, prepare the emergency drive hose, turn off the machine, and remove the high-pressure tubing joint on the hydraulic motor. Turn off the rescue vehicle, remove the high-pressure oil pipe of the hydraulic motor, and connect it with the corresponding joint of the faulty vehicle using the emergency drive hose.

　　发动救援车并将操作手柄拨动出料位置，故障车中的混合便会被排出。当紧急驱动完成后，将自动上料搅拌车中的驱动软管拆卸，并回复原状。在拖轮、滚道间放入木楔，并控制搅拌筒的旋转，将发动机熄火，将液压马达的一根高压油管拆卸。

　　Start the rescue vehicle and move the operating handle to the discharging position, and the mixture in the failure vehicle will be discharged. When the emergency drive is complete, remove the drive hose from the automatic feeding mixer and return it to its original state. Put wooden wedges between tugboats and raceways, and control the rotation of the mixing cylinder, turn off the engine, and remove a high-pressure oil pipe of the hydraulic motor.

　　搅拌筒可自由旋转并控制搅拌筒的旋转。从而让维修孔转到下部位置，然后将维修孔打开，并清理出筒中的混凝土，当混凝土排出完成后，恢复自动上料搅拌车的原来状态即可。

　　The agitator can rotate freely and control the rotation of the agitator. So that the maintenance hole to the lower position, and then open the maintenance hole, and clean up the concrete in the cylinder, when the concrete discharge is complete, restore the original state of the automatic feeding mixer.

　　在检查、修理搅拌车液压传动部分时，应使发动机和液压泵在没有压力的情况下进行。在调整混凝土搅拌车各部间隙、行程、压力时，应由专职员检查同意；更换机件时，须由部长或主管经理签字，否则出现问题后追究有关人员责任。

　　When inspecting and repairing the hydraulic transmission part of the agitator, the engine and hydraulic pump should be carried out without pressure. When adjusting the clearance, stroke and pressure of each part of the concrete mixing truck, the full-time safety officer should check and agree; When replacing parts, it must be signed by the minister or the manager in charge, otherwise the relevant personnel will be held responsible after problems occur.

　　自动上料搅拌车作业中出现土渣问题要怎么处理？以上的方法希望能够给您帮助，当然要想搅拌车长久的运行就要做好日常保养工作哦。更多内容就来网站www.jfhntjbj.com咨询吧！

　　How to deal with the problem of soil slag in the operation of automatic feeding agitator? The above methods hope to help you. Of course, if you want to run the mixer for a long time, you must do a good job in daily maintenance work. More content to the website www.jfhntjbj.com consultation!