搅拌一体车作为一种建设机械产品，对于提高施工效率，降低成本起着很大的作用，但是在施工过程中要注意正确操作，下面是搅拌一体车的操作流程：

As a construction mechanical product, the mixer truck plays a very important role in improving construction efficiency and reducing costs. However, attention should be paid to correct operation during construction. The following is the operation process of the mixer truck:

1、停车

1. Parking

将搅拌一体车行驶停放到工作区，拉好手刹将档位拨空挡熄火，注意要将泵车停在泵送臂架工作范围内。

Drive the mixer truck and park it in the working area. Pull the hand brake and turn the gear to neutral to stop the engine. Pay attention to parking the pump truck within the working range of the pumping arm.

2、转换发动机工作状态

2. Switch the engine working state

将电控箱操作面板上的行车开关转换泵送位置，启动底盘发动机，将底盘档位挂到6档，同时检查搅拌机电箱、支腿与臂架转换位置、主电控箱、泵车无线遥控器和搅拌机有线遥控的急停开关是否有打开。

Switch the traveling switch on the operation panel of the electric control box to the pumping position, start the chassis engine, shift the chassis gear to gear 6, and check whether the emergency stop switches of the agitator box, outrigger and boom switch positions, the main electric control box, the wireless remote control of the pump truck and the wired remote control of the mixer are turned on.

3、伸展支腿

3. Stretch outriggers

将臂架支腿转换开关切换到支腿位置，依次将六条泵机支腿展开。注意将支腿下方垫木方，这样是用支承板或辅助方木来增大支承表面积，从而保持整车的平衡。

Switch the boom outrigger change-over switch to the outrigger position, and unfold the six pump outriggers in turn. Pay attention to cushion the wooden square under the outrigger. In this way, the bearing plate or auxiliary square timber is used to increase the bearing surface area, so as to maintain the balance of the whole vehicle.

4、伸展臂架

4. Extension boom

将臂架支腿转换开关切换到臂架位置，将大臂伸开。

Switch the boom outrigger change-over switch to the boom position and extend the boom.

5、支撑搅拌机

5. Support mixer

拔出搅拌机定位销，将搅拌机推动到工作位置，插好定位销。放下上料斗上下滑道，连接好固定螺栓。

Pull out the positioning pin of the mixer, push the mixer to the working position, and insert the positioning pin. Lower the upper and lower slides of the upper hopper and connect the fixing bolts.

6、启动发电机

6. Start generator

启动时要注意看发电机组空气开关是否处于断开状态，不能带负荷启动，以免影响发电机消磁。

When starting, pay attention to whether the air switch of the generator set is in the off state, and do not start with load to avoid affecting the degaussing of the generator.

7、开始泵送

7. Start pumping

将混凝土原料放入泵车料斗，等待混凝土搅拌好后，将搅拌好的混凝土放入料斗连续泵送。

Put the concrete raw materials into the hopper of the pump truck, wait for the concrete to be mixed, and then put the mixed concrete into the hopper for continuous pumping.

8、清洗

8. Cleaning

泵送完毕后，要对搅拌一体车进行清洗，先清洗干净料斗内的混凝土，然后冲洗料斗。

After pumping, the mixer truck shall be cleaned. First, the concrete in the hopper shall be cleaned, and then the hopper shall be washed.

9、关闭发电机组

9. Shut down the generator set

断开空气开关，将发电机组柴油机转速降低速运转30秒后关闭发电机组。

Disconnect the air switch, reduce the speed of the diesel engine of the generator set to low speed for 30 seconds, and then shut down the generator set.

10、收车

10. Collection

将搅拌一体车收到行车状态，插好定位销，依次收好臂架和支腿，将底盘档位拨空挡，将转换开关切换行车状态。

After receiving the driving status of the mixer truck, insert the positioning pin, put the boom and outrigger in order, shift the chassis gear to neutral, and switch the change-over switch to the driving status.

搅拌一体车属于特种工程机械，作业前一定要经过培训考核合格才能操作。毕竟为重，不能大意，您有什么问题就来我们网站http://www.jfhntjbj.com咨询吧！

The mixer truck belongs to special construction machinery, and must pass the training and examination before operation. After all, safety is the most important thing. Don't be careless. Come to our website if you have any problems http://www.jfhntjbj.com Consult!