正确使用自动上料搅拌车有利于施工的顺利进行，并且可以提高工程工作效率，如果没有正确使用会损害设备的机械部件，减少它的使用寿命。今天就让小编为大家简单介绍一下自动上料搅拌车散热器的正确使用方式：

The correct use of the automatic feeding mixer is conducive to the smooth construction, and can improve the work efficiency of the project. If it is not used correctly, it will damage the mechanical parts of the equipment and reduce its service life. Today, let's brief you on the correct way to use the radiator of the automatic feeding mixer:

1、备用的散热器有效环境应保持通风、干燥。

1. The effective environment of the standby radiator shall be ventilated and dry.

2、建议使用软硬水需软化处理后使用，避免造成散热器内部堵塞及水垢的产生。

2. It is recommended that soft and hard water should be softened before use to avoid blockage and scale inside the radiator.

3、在冬季为防止结冰造成芯子破裂现象，如搅拌车长期停车或间接停车时，应将水箱盖和放水开关，将水全部放出。

3. In winter, in order to prevent core fracture caused by ice formation, if the mixer truck is stopped for a long time or indirectly, the water tank cover and drain switch shall be used to drain all water.

4、水位计应每3个月清洗一次或视实际情况，各部件拆下用温水加无腐蚀性洗涤剂清洗。

4. The water level gauge shall be cleaned every 3 months or as the case may be, each component shall be removed and cleaned with warm water and non corrosive detergent.

5、散热器内完全放水再注水时，要先将发动机缸体的放水开关扭开，有水流出时，再关上，从而避免产生水泡。

5. When the radiator is completely drained and refilled, turn on the water drain switch of the engine block first, and then turn it off when there is water flowing out, so as to avoid water bubbles.

6、在日常使用中应随时检查水位，要停机降温后加水。加水时，将水箱盖慢慢打开，作业人员身体应尽量远离加水口，以防高压蒸汽油加水口喷出造成烫伤。

6. Check the water level at any time during daily use, and add water after shutdown for cooling. When adding water, slowly open the water tank cover, and keep the operators away from the water inlet as far as possible to prevent scalding caused by the spray of high-pressure gasoline.

7、散热器不应与任何酸、碱或其它腐蚀性性质接触。

7. The radiator shall not contact with any acid, alkali or other corrosive properties.

8、在使用防冻液，为了避免散热器的腐蚀，请务必使用正规厂家生产且符合标准的长效防锈防冻液。

8. When using antifreeze, in order to avoid the corrosion of the radiator, please be sure to use a long-term anti rust antifreeze produced by a regular manufacturer and meeting the national standard.

9、视实际情况用户应在1～3个月间对散热器进行完全清洗一次芯体。清洗时，用清水沿反进风向侧冲洗。

9. Depending on the actual situation, the user shall completely clean the core of the radiator once within 1-3 months. When cleaning, use clean water to wash along the reverse wind direction.

10、在安装散热器过程中，请不要损坏散热带（片）和碰伤散热器，以保证散热能力和密封。

10. During the installation of the radiator, please do not damage the radiator ribbon (fin) or damage the radiator to ensure the heat dissipation capacity and sealing.

使用时的重中之中是要严格按照使用说明进行操作，一般在夏季如果自动上料搅拌车温度过高应该立刻停下来，等温度降下来后再继续使用。关注我们http://www.jfhntjbj.com，了解更多相关事项！

The most important thing is to operate in strict accordance with the instructions. Generally, if the temperature of the automatic feeding mixer is too high in summer, it should stop immediately and continue to use after the temperature drops. Follow us http://www.jfhntjbj.com , learn more about it!