搅拌一体车在使用过程中也会因为缺少一些养护或者什么原因，而导致相关问题的出现，所以在此小编给您几个参考事项，您可以看看。

During the use of the mixer, related problems may occur due to lack of maintenance or some other reasons, so here are some reference items for you to see.

注意事项：

matters needing attention:

1、各传动齿轮、减速箱、链条等是否按规定加足润滑油；

1. Whether all transmission gears, reduction boxes, chains, etc. are fully lubricated as required;

2、搅拌筒运转平稳，衬板、叶片、没有松动现象

2. The mixing drum operates stably, and the lining plates and blades are free from looseness

3、传动部分声音是否正常，减速箱、轴承是否有发热或漏油现象；

3. Whether the sound of the transmission part is normal, and whether the reduction gearbox and bearing have heat or oil leakage;

4、传送带松紧度是否合适，传动链条中部下沉不得大于20mm；

4. Whether the tightness of the conveyor belt is appropriate, and the middle of the drive chain should not sink more than 20mm;

5、钢丝绳有无较大磨损，连接是否牢固；

5. Whether the steel wire rope is severely worn and firmly connected;

6、制动器和离合器性能是否良好，制动片是否磨损严重，需不需要更换。

6. Whether the performance of the brake and clutch is good, and whether the brake pads are seriously worn. It is unnecessary to replace them.

日常维护工作：

Daily maintenance:

按照规定在每一次主机启动时给搅拌机轴端密封定时加油，以保证油封结构长期正常运转；

Oil the shaft end seal of the mixer regularly at each start of the main engine as required to ensure the normal operation of the oil seal structure for a long time;

检查其他的加油点如各转动、转动轮和轨道等是否需要加油。

Check whether other refueling points such as rotating wheels, rotating wheels and rails need refueling.

检查易损部件，如衬板、叶片、搅拌臂等，及时调整或更换。

Check vulnerable parts, such as lining plate, blade, mixing arm, etc., and adjust or replace them in time.

保养机体的清洁，清除机体上的污物和障碍物。

Maintain the cleanness of the body and remove dirt and obstacles on the body.

检查各润滑处的油料及电路和控制设备，并按要求加注润滑油。

Check the oil, circuit and control equipment at each lubrication point, and add lubricating oil as required.

搅拌一体车运转过程中，应随时检听电动机，减速器，传动齿轮的噪声是否正常，温升是否过高。

During the operation of the mixer truck, check whether the noise of the motor, reducer and transmission gear is normal and whether the temperature rise is too high.

每班工作前，在搅拌筒内加水空转1--到2min，同时检查离合器和制动装置工作的可靠性。每班工作结束后，应认真清洗搅拌一体车。关注我们http://www.jfhntjbj.com，了解更多！

Before each shift, add water into the mixing drum and idle for 1 - to 2min, and check the reliability of the clutch and brake device. After the work of each shift, the mixer truck shall be carefully cleaned. Follow us http://www.jfhntjbj.com , learn more!